Multi Zone Horizontal Tube Furnaces - TMH16(Z3)

• The TMH16(Z3) furnaces are designed to give a longer uniform centre zone temperature than that of the single zone tube furnace models.
• All TMH16(Z3) models are controlled by retransmission of set point from the centre zone controller to the end zone controllers.
• Independent control of each zone is also available.
• This system provides a longer uniform zone temperature than that achieved by the use of single zone furnace of the same length
• A work tube is not supplied as an integral part of the furnace and therefore needs to be ordered with the furnace as it is an essential accessory.
• Protective outer mesh covers for improved operator safety.
• Low thermal mass insulation used throughout for maximum thermal efficiency and stability
• 'R' Type Thermocouples are used in these furnaces.
• High end Microprocessor PID controller.
• Horizontal models are supplied as standard with controls in the base.

• Work tubes of various materials, lengths and diameters for use in the furnace
• Two or more zones are also available
• Independent control of each zone is also available
• The work tubes are available for containment of atmosphere or protection against process contaminants
• A variety of triple flange gas tight end seals for work tubes to allow processing under Vacuum or gas atmospheres
• Over Temperature protection controller
• Multi segment, multi program storage controllers
• Thermal Radiation Screens/Shields

Note 1:

The work tube is not supplied as an integral part of the furnace and therefore needs to be purchased with the order as it is an essential accessory.

Note 2:

For Multi-zone Tube furnaces, we can supply:

1. Two or more zones.
2. Split-tube furnaces with multi-zone configuration also available.
3. Other temperatures that are not specified.
4. Other Tube diameters and lengths that are not specified