Multi Zone Tube Furnaces - TMV17

• The TMV furnaces are designed to give a longer uniform centre zone temperature than that of the single zone tube furnace models of the same length.
• All TMV models are controlled by retransmission of set point from the centre zone controller to the end zone controllers.
• Low thermal mass insulation used throughout for maximum thermal efficiency and stability.
• 'B' type Thermocouples are used in these furnaces.
• A work tube is not supplied as an integral part of the furnace and therefore needs to be ordered with the furnace as it is an essential accessory.
• High end Microprocessor PID controller.
• Over temperature protection is included in the standard specification.
• Horizontal models are supplied as standard with controls in the base.
• Phase angle fired thyristor units operating in conjunction with low voltage secondary isolating transformers providing the correct parameters for the heating elements.

• Work tubes of various materials, lengths and diameters for use in the furnace.
• The work tubes are available for containment of atmosphere or protection against process contaminants.
• A variety of triple flange gas tight end seals for work tubes to allow processing under vacuum or gas atmospheres.
• Multi segment, multi program storage controllers.
• Thermal radiation plugs.

Note:

For Multi-zone Tube furnaces, we can supply:
1. Two or more zones.
2. Other temperatures that are not specified
3. Other Tube diameters and lengths that are not specified.Custom Designed.